This morning my Compaq laptop running eCS 1.1 refused to complete 
booting due to trap 6, e, and d in various modules, including the 
kernel, hpfs, afinetk (or close to it), pmshell.  Power off and reboot 
would get part way thru boot, and then another trap in some module. 
There was only one trap 6, the majority being trap d and a few trap e.

I could boot WinXP on the same system with no problems, and in fact did 
so several times.  Suspecting a memory problem, I downloaded Memtest86 
and ran it thru a couple of passes over more than an hour, with no 
errors discovered.

Following the memtest86 run, I booted into eCS with out any problems 
whatsoever.

Does this indicate a possible intermittant memory problem, or maybe some 
other component getting flakey, like maybe a bus, disk I/O, or a drive 
going bad?

Thanks for any thoughts.

-- 
Jim Showalter
jshowalt{at}mindspring.com


------------------------ Yahoo! Groups Sponsor --------------------~--> 
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!
http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/9rHolB/TM
--------------------------------------------------------------------~-> 

 
Yahoo! Groups Links

 To visit your group on the web, go to:
    http://groups.yahoo.com/group/os2hardware/

 To unsubscribe from this group, send an email to:
    os2hardware-unsubscribe{at}yahoogroups.com

 Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




---