WN-> Both Com1 1 & 2 locked at 115200 baud. As for the connect speed, you 
need 
  -> set your modem to return the DCE connect speed, not the DTE connect 
speed.
 
Ok it is set to return the DCE connect speed, to which it is doing.
 
  -> you've got that done, then I'd say you have a software config problem
  -> somewhere. If your BBS software recognizes the DCE connect rate, then 
your
 
I tend to agree with you, I can't find anywhere that the modem is not
doing what it is configured to do, thus it has got to be a software
problem somewhere as you say.
 
  -> protocol should also. BTW, I'd up the locked rate to at least 57600. 
38400
  -> just too slow for a 33.6K modem.
 
I did have it set at 57600, but the author of the software said to lower
it to 38400 so I took it back down.
I am getting good transfer speeds at either locked setting though.
Thanks for the reply :)
 
 * OLX 1.53 * Black holes are where God divided by zero.
--- TriToss (tm) Professional 11.0 - #108
---------------