On Mon, 17 Sep 2007 15:39:01 -0700, Martin Rosenfeld wrote:

>
>I never had to specify COM ports before. What syntax would I use to try?
>


Samples from the Command Reference, located in your help folder:

To install a serial device on COM4 for ISA/EISA bus computers, type
the following in the CONFIG.SYS file: 

DEVICE=C:\OS2\BOOT\COM.SYS (4,2e8,10)


To install serial devices on COM3 and COM4 for ISA/EISA bus
computers, type the following in the CONFIG.SYS file: 

DEVICE=C:\OS2\BOOT\COM.SYS (3,3e8,5) (4,2e8,9)

The first parameter is com port, the next is the standard i/o port
for said com port, and the last is the IRQ line that the device is
set to.  This refers to a device where you set the IRQ with
switches or vendor software.

This will work on pci also if you can set certain slots to legacy
mode.

Jon


 
Yahoo! Groups Links

 To visit your group on the web, go to:
    http://groups.yahoo.com/group/os2hardware/

 Your email settings:
    Individual Email | Traditional

 To change settings online go to:
    http://groups.yahoo.com/group/os2hardware/join
    (Yahoo! ID required)

 To change settings via email:
    mailto:os2hardware-digest{at}yahoogroups.com 
    mailto:os2hardware-fullfeatured{at}yahoogroups.com

 To unsubscribe from this group, send an email to:
    os2hardware-unsubscribe{at}yahoogroups.com

 Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 

---