Before someone jumps me....This deals with a DOS based BBS
package...>g<
       Alright, this problem deals with two different systems on a 3 node
LAN....
       1 & 2 -> Pentium Pro 150's, 32 & 64M of ram, etc..
       I just added SoundBlaster 16PNP's to the systems, and things have
gone "blewy".
       #1) Can find the network....I've confirmed that there appears to be
               nothing interferring with it's memory locations, but...
       #2) When I bring up the DOS BBS without the named Pipe support,
               it works fine.  But with the Named Pipe Support running,
               it Trap's the System.
       The named pipe support goes to \\nekobus, which is running the
       Internode Communication driver... \\totoro (#2) worked fine
       before...But now it's blowing up...
       What I did on totoro was...
               - Install the Board
               - Run Selective Install for Warp
               - Added the SB16PNP driver from Selective Install
               - Re-installed Fix Pak #2
               - Re-installed the Matrox Mil. Drivers... (Probably
                       wasn't needed)
       I see nothing that should interfer with network named pipes...
       Everything else is working fine drive mapping, etc...Just not
       the named pipes...
       \\shelran, (#1) I did the same, except I also selective
       installed DOS support...
       Both systems are tied to the BBS through the lan...
       I'd appreciate it if anyone could give a hand...
       - Benjamin
               (bscholl@eznet.net)
... Windows: Next best thing to sand in your hard disk.
-*- TurboEDIT v1.7á1 [MSP97]
--- QuickBBS 2.85 (Beta-10) GoldBase
---------------