Mike,

  > When you installed RC2 - did you notice whether the selection for
> PCI-COM ports was selected -
I usually do check install COM ports. I think I forgot because COM.SYS 
and VCOM.SYS were not in config.sys. After your message I added them and 
rebooted.

> What config.sys entries do you have for *com.sys?

DEVICE=Q:\OS2\BOOT\COM.SYS
DEVISE+Q:\OS2\MDOS\VCOM.SYS

> Do you need to specify the actual IRQs-I/O ports individually on the COM 
> drivers in config.sys?

I never had to specify COM ports before. What syntax would I use to try?

Martin



 
Yahoo! Groups Links

 To visit your group on the web, go to:
    http://groups.yahoo.com/group/os2hardware/

 Your email settings:
    Individual Email | Traditional

 To change settings online go to:
    http://groups.yahoo.com/group/os2hardware/join
    (Yahoo! ID required)

 To change settings via email:
    mailto:os2hardware-digest{at}yahoogroups.com 
    mailto:os2hardware-fullfeatured{at}yahoogroups.com

 To unsubscribe from this group, send an email to:
    os2hardware-unsubscribe{at}yahoogroups.com

 Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 

---