MS> > At first I thought that it was just the Couriers that were
MS> > affected,  but it appears now that all of my previously reported
MS> > 28800 connects  have now become 26400 connects. On one connect
MS> > that I watched  yesterday, the display showed rx26/tx28 but on
MS> > others it showed both  ways 26. I've sent e-mail to betarep. I
MS> > will continue to use the  1.44 unless the connects degrade
MS> > further.  I've also posted in the BINKLEY echo, in case there are 
MS> > configuration changes in Bink that I should have made.
MS> PM>  What do you currently have S191 set to?
MS> PM>  Try reducing is a few numbers and see if it helps.
MS>The setting was 129, apparently changed from the default 128 in the
MS>1.3 rom. I tried reducing it by twos down to 121 without effecting
MS>any apparent change in the connect rates with the 33.6 capable
MS>the Courier that I'm most concerned about, NEC. The connects
MS>continued to be at 26400. I jumped to S191=111 and still no change. I
MS>have reset it to S191=128 unless you think that further
MS>experimentation with that setting would be worthwhile.
        Interesting.  Then it is something acting differently at the
        remote end (it as final say in the carrier rate it uses to
        send data to your end).  I don't know the Couriers that well,
        but if they have a Bias adjustment, it my need to be set a 
        bit more aggressively.
CMPQwk1.42 331þWhere does the data written to device NUL go?
--- FLAME v1.1
---------------