Patrick Moore wrote in a message to Martin Schiller:
 > At first I thought that it was just the Couriers that were affected, 
 > but it appears now that all of my previously reported 28800 connects 
 > have now become 26400 connects. On one connect that I watched 
 > yesterday, the display showed rx26/tx28 but on others it showed both 
 > ways 26. I've sent e-mail to betarep. I will continue to use the 
 > 1.44 unless the connects degrade further. 
 > I've also posted in the BINKLEY echo, in case there are 
 > configuration changes in Bink that I should have made.
 PM>  What do you currently have S191 set to?
 PM>  Try reducing is a few numbers and see if it helps.
The setting was 129, apparently changed from the default 128 in the 1.3 rom. 
I tried reducing it by twos down to 121 without effecting any apparent change 
in the connect rates with the 33.6 capable Courier that I'm most concerned 
about, the NEC. The connects continued to be at 26400. I jumped to S191=111 
and still no change. I have reset it to S191=128 unless you think that 
further experimentation with that setting would be worthwhile.
Regards, Martin 
--- 
---------------