In , on 04/26/2005 
   at 11:04 AM, "David Eckard"  said:

>In , on 04/26/2005 
>   at 09:50 AM, bokeny{at}earthlink.net said:

>>Loading Realtech Fast Ethernet Network Adapter diver (3.23vk)
>>[2004-07-28]

>>next line make no sense, but ends with Ether ID={at}????????????

>More n likely that ID is your mac address.


>>driver installation failed
>>Error: BIOS did not assigned IOBase for device
>>1, Please check setup
>>2, force use of IOBase in protocol ini

>Check the various interrupts and IO addresses your system is using.  
>Sounds like the protocol.ini file isn't right

Hi David
I compared the protocol.ini on my tower pc with my ThinkPad, and except
for different drivers, both are setup the same way.  The network adapter
does not show up in the Hardware Manager, so I don't know what else to
check.  The MPTN\BIN\SETUP.CMDs are different considerably.  Should I
try to make them alike?  Right now I am only hooked up to a router which
is hooked to a broadband modem.

Regards,
Zoltan

--
Zoltan Bokeny 
bokeny at earthlink dot net
OS/2 Warp 4 / eCS 1.2 - MR/2 ICE V2.67 #20296
FAPCUG - POSSI - SCOUG - TOUG - VOICE
Fayetteville, North Carolina



 
Yahoo! Groups Links

 To visit your group on the web, go to:
    http://groups.yahoo.com/group/os2hardware/

 To unsubscribe from this group, send an email to:
    os2hardware-unsubscribe{at}yahoogroups.com

 Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




---