Hi Mvan,

 ML> So how do I send netmail (to my NC) if I haven't got a FidoNet address ?

If you don't have a Fidonet address then you don't have an NC, because you
do not have a Nodelisting. When you wish to apply for a Node number, then
your have 2 main methods you can follow -
  1. Follow the method described in the Fidonet Policy4 document (this
method ensurs that you HAVE read P4).
  2. In some cases your local NC will provide specific additional
instructions usually via other nodes within the Net.

This process requires you to -
  1. Compile a Nodelist that contains the address you need to use.
  2. it also demonstrates that you know how to configure your Nodelist processor.
  3. Poll the node specified in P4 (or your local Network instructions).
  4. You should receive further instructions on the next step.

The entire process is designed to demonstrate that you know HOW to use your
Software and follow instructions.

 ML> Do I have to add a fake node to the nodelist and recompile the nodelist?

In most cases yes, but you need to check on what specifics your NC may
require first. 

 ML> Impersonating an existing address works.

That is considered extremely bad and could trigger alarms of malicious
intent, and preclude the issuing of a Node address. It is not recommended.

 ML> When not specifying an "Address" statement in 
 ML> Binkley.cfg the default node is Node: 1:65535/65535. 

That is a "default" settng that does not allow you to do much
other than at least see if Binkley runs. When that no. is used Binkley
ignores anything in your Outbound because it knows you should have a valid
address.

 ML> And if I use an unlisted address BinkleyTerm exits with 
 ML> "System misconfigured or no entry in Nodelist":

Because you need to work out how to create a Nodelist that is VALID for the
purposes you need.

Cheers............pk.


--- Maximus/2 3.01