PW>Most likely you have lost your negative bias supply.  Pull the output
PW>tubes and check for a negative voltage of about -40 to -50 between 
PW>the chassis and pin 5 on both the tube sockets.  If it is there then 
PW>you have other problems suck as leaky caps between the phase splitter
PW>(12AT7) and the 6L6 grids.  There is also a 1K5 gris stopper resistor
PW>mounted directly on the 6L6 sockets.  These go open quite often and 
PW>will cause the same effect.
Thanks for the comeback. I have stored your reply and will print it out 
and store it with my amp data. Then, hopefully, I'll get at that amp. 
Don
-+- OLMS 2.53p UNREG
--- FMail/386 1.22
---------------