> MS>I applied the beta flasher to my SFM288 and the connect rates to 
 > my
 > MS>two USR Courier links dropped from 28800 to 26400. I can't think 
 > what
 > MS>I've forgotten. Could someone prompt me?
 > 
 >PM>         Did you issue AT&F2&W&W1Z and cycle power after the
 >PM> upgrade?         
 >PM>         (If not, try it.)
 > 
 > I think that I might have forgotten the "cycle power" during the 
 > original flash, so I tried the procedure as listed in the readme 
 > file and the way you suggested - but there was no change in 
 > operation. I also flashed a second SFM288 following the procedure 
 > precisely, and so far it appears to be behaving the same as the 
 > first one. 
 > At first I thought that it was just the Couriers that were affected, 
 > but it appears now that all of my previously reported 28800 connects 
 > have now become 26400 connects. On one connect that I watched 
 > yesterday, the display showed rx26/tx28 but on others it showed both 
 > ways 26. I've sent e-mail to betarep. I will continue to use the 
 > 1.44 unless the connects degrade further. 
 > I've also posted in the BINKLEY echo, in case there are 
 > configuration changes in Bink that I should have made.
 What do you currently have S191 set to?
 Try reducing is a few numbers and see if it helps.
 -Patrick
--- FLAME v1.1
---------------