From: Kyle Watkins 
Frank Vlamings[SMTP:fpv@best.com] wrote:
> -- --
> 
> I now have the new v2.50E working just right. I have only one very minor
> nuisance to me, I would like to see corrected, and that is the following.
> 
> How can I convert the color settings from my present v2.50E to what I had
> in my v2.50A? I still have all the files of my older v2.50A in another
> partition, but would like to have the color scheme and other settings of
> v2.50A to work in my new v2.50E. I have tried it manually and save that,
> but for some reason, it just is not quite the same setting, I have in my
> v2.50A.
Hi Frank,
I'm not sure what manual method you used, but to be sure,
try the following:
Log into the directory where your TSE Pro v2.50A is located.
From this directory, run TSE Pro v2.50A.
Once you are in editing mode, access the Main Menu, select the 
"Options" menu, then "Full Configuration", and finally 
"Write Settings to ASCII File".
Specify the filename as FRANK.CFG and save it to the directory
where your TSE Pro v2.5E is located.
Now, exit TSE Pro v2.50A and log into the directory where your
TSE Pro v2.5E is located.  
From this directory (assuming your copy of TSE Pro v2.5E is named
E.EXE) run:
SC -b FRANK.CFG
This should burn-in the settings of FRANK.CFG into the editor.
Now run your copy of TSE Pro v2.5E and verify that the colors
are set correctly.
Once you have verified that all is ok:
If you already have an active "#include" statement in your 
".UI" file, you will want to be sure to make the appropriate 
changes to account for the FRANK.CFG file.
Let me know if you have any problems.
Kyle Watkins (SemWare Support)
---
---------------