BL> And it was failing on the UPLOAD too, except that *my*
BL> end was correcting. I get an "F" warning in telix, which
BL> means that I am overdriving your end and then wait. I *always*
BL> get this uploading at 14400 and so does Brenton at 28800,

And F with Telix is flow control, not 'correcting'

You will obviously get it showing if the modems are retrying
between themselves due to errors, but you will also get it
when the rate at which data goes into the modem from your
computer is faster than it can pump it up the phone line too.

BL> but it's the first time I've seen it at 2400.

Maybe you set the serial speed low to get 2400
or something, so it doesnt need to flow control.

BL> It's a bit hard to work out how I could
BL> overdrive your data port at 2400 baud.

Depends on what serial speed you are using.
@EOT:

---