In , on 11/06/05 
   at 03:39 PM, Robert Gammon  typed:

>Rather than copying the entire block that you included, it then seems 
>that the IDE to SCSI bridge has a problem with support for the CD-RW 
>command set. Seems quite odd as the command set has been around a LONG
>time.

>The only issue I see perhaps, is that SCSI has the ability to disconnect 
>from the bus while the device operates on the command. Then when the 
>device is ready, it signals the host that data transfer is ready to 
>begin, the host acknowledges and the device starts the transfer. Now 
>blanking a CD-RW does not require such, HOWEVER, the IDE CD-RW device 
>may not be cooperating fully and get the bridge and/or the host adapter 
>confused about the device's state.

I may have missed the start of this thread, but which version of ASPIROUT
is being used?  I had problems with CDRECORD until I got a newer version

aspirb9.zip (aspirout)	from Hobbes - 	pub/os2/system/drivers/scsi	
 
-- 
 Julian Thomas:   jt{at}jt-mj.net    http://jt-mj.net
 In the beautiful Finger Lakes Wine Country of New York State!
 -- --
 Weinberg's Law: If builders built buildings the way programmers wrote 
 programs, then the first woodpecker that came along would destroy civilization.





------------------------ Yahoo! Groups Sponsor --------------------~--> 
Get fast access to your favorite Yahoo! Groups. Make Yahoo! your home page
http://us.click.yahoo.com/dpRU5A/wUILAA/yQLSAA/9rHolB/TM
--------------------------------------------------------------------~-> 

 
Yahoo! Groups Links

 To visit your group on the web, go to:
    http://groups.yahoo.com/group/os2hardware/

 To unsubscribe from this group, send an email to:
    os2hardware-unsubscribe{at}yahoogroups.com

 Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 



---