Robert Traynor (BobT) wrote:
> Hi Ed,
> 
> Answers below..
> 
> On Sun, 27 Nov 2005 20:11:52 +1100, Ed Durrant wrote:
>> Hi Bob,
>>
>>    No to both of the questions below, however I now have the card and 
>> drive working !!
>>
>>    In addition to the two on-board EIDE controllers on IRQ 14 and 15, 
>> this additional (AUS$29.00) Connectland, Silicon Image SIL3112 based 
>> card (with RAID chip as well, but not supported under OS/2), works with 
>> the latest DANI driver (v 1.7.4) on IRQ 11, with the following 
>> Config.sys command line:
>>
>> BASEDEV=DANIS506.ADD /A:1 /BM /U:0 /ATAPI /RMV /U:1 /ATAPI /RMV /A:2 /U:0 /V
> 
> 
> 
> Interesting parameters, I must read the Dani Docs again to refresh my memory.
> Thanks for reporting the success in such detail.  I will save it for future use.
> 

The only relevant to the new card, parameters are the /A:2 and /U:0 - 
before I added these the driver did not "realise" that the new card was 
there (or that's my interpretation). It could be that up to that point I 
had a bad contact on the cable or anything - anyway this config works.

Cheers/2

Ed.


------------------------ Yahoo! Groups Sponsor --------------------~--> 
Get fast access to your favorite Yahoo! Groups. Make Yahoo! your home page
http://us.click.yahoo.com/dpRU5A/wUILAA/yQLSAA/9rHolB/TM
--------------------------------------------------------------------~-> 

 
Yahoo! Groups Links

 To visit your group on the web, go to:
    http://groups.yahoo.com/group/os2hardware/

 To unsubscribe from this group, send an email to:
    os2hardware-unsubscribe{at}yahoogroups.com

 Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




---