Julian:
I picked up a pci Buslogic scsi card just for this purpose for less than
$5. But several years ago, I switched from the 25 pin cable to a proper
shielded 50 pin cable for the HP. I've since moved the HP4p to a similar
Adaptec 2940 with a 50 pin external port. 

An Advansys scsi card WILL NOT WORK. Hours and hours wasted. 

All the old software, such as copyshop, the danmar copier, and CFM
twain-enabled sw works. As does sane/tame.

said Harry, stirred by:
     "Julian Thomas" 's message of:
     Friday 17 Feb 06 at 10:29 PM,
     On: Re: [OS2HW] Re: SCSI under IDE
     [echoed below, at least in part]

--------
In , on 02/18/06 
   at 02:52 AM, "kish_44"  typed:

>Finally, tonight, I moved the desk, pulled a Hewlett Packard 4c scanner
>out of its cozy little spot, plugged it into the card, and I can now see
>the Adaptec controller (and the scanner).

I'm curious.  I have a HP 4P scanner that came with a short ISA
quasi-scsi adapter card (with a DB connector rather than the smaller
SCSI connectors).  It is running on my Warp 4 system on the only
machine in the house that still has an ISA slot with CopyShop.

What would it take to get it to run on a PCI only system and what
software would I be wanting to use (I'm very unsure of getting CopyShop
to work with stock SCSI drivers).  I do have an Epson 2400 USB attached
that works well with Tame.
 

HPT
-- 
-----------------------------------------------------------
htravis at attglobal dot net
DemostiX
-----------------------------------------------------------





 
Yahoo! Groups Links

 To visit your group on the web, go to:
    http://groups.yahoo.com/group/os2hardware/

 To unsubscribe from this group, send an email to:
    os2hardware-unsubscribe{at}yahoogroups.com

 Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 



---