PL>> You should switch from Com/IP to NetSerial... 25 bux to register under the
PL>> SysOp deal.  Far superior than Com/IP.  Evrything I have tried it out with
PL>> works fine, even stuff I couldn't get to work right under Com/IP.  You
PL>> don'
PL>> need to worry about all those crazy S registers used with Com/IP either.
PL>> Ez
PL>> will probably work with just AT&D2| for the init string.

 TJM> I'm holding off until they add the IP logging ... hopfully they
 TJM> take my
 TJM> suggestion and add it via the extended log infomation (CONNECT
 TJM> 57600/ARQ/ID_XXX_XXX_XXX_XXX .... yaknow, like the phone number ID
 TJM> ...)  then
 TJM> I'm gonna pull the switch.

I gotcha... I just fired off an e-mail to Mike Ehlert to ask him if there
was any intention of having that included in the future... and mentioned
that I think it would be good to have.  Another voice for it, maybe it'll
help :)

BTW... logging onto Titantic earlier today (and then just again now to make
sure I was right) I noticed you are running FD... have you yet made use of,
or even heard of, make000?  Basicly a little nodelist converter that will
take the IP info of any ITN or IVM node and place it in field 6. Removes
the need for having to do any node overides for any and all telnet and IVM
nodes in the nodelist... simply enter a netmail, set crash/direct and it
will fly out over your virtual modem just as if it were a POTS connection,
but of course with much higher transfer rates.  It's a beautiful thing. 
I've never seen my FD work so good since I was a POTS only system.

Phil

--- FMail/Win32 1.60
Netwo (1:267/169)