Hello Dave!

Wednesday January 24 1996 18:35, Dave Hatch wrote to Deon Attard:

 DA>> Any idea what the command/s register is to enable the
"aggression" :-)
 DA>> Sounds like an experiment to me..

 > On the Netcomm, the hardware's there.  They do their own software, so it
 > probably will take a bit of poking about to find what they call it, or if
 > they've implemented the manual adjust feature.

 > On my Hayes v34, it's in S108, labeled Signal Quality Select, range of 0 -
 > 3, with 0 putting up with anything, and 3 demanding perfection on pain of

On the Supra V.FC and V.34 models,

S191    EQM Automatic Rate Adaption Bias (0-255, Zero Bias 128, Default 130)
         This adjustment affects V32,V32B,VFC,& V34 operation.  The bias
         offset is summed with the EQM(%Q) reading to determine the carrier
         rate to select during initial TRAIN and RE-TRAINS (Rate Renegotiation
         (Fall Back/Forward) & %Q reading are NOT affected by the S191 setting)
        -Positive bias (values above 128) tends to DECREASE the initial carrier
                rate for a given connection.
        -Negative bias (values below 128) tends to INCREASE the initial carrier
                rate for a given connection.

Can't remember what I use, both lines in use at present.

Regards,
Hamish

--- GoldED/P32 2.42.G1219+