I have a laptop with a built-in, multi device card reader.  PCI.EXE 
reports what is below.  Is is S506.ADD that is mostly involved in 
using PCI devices?  Does DANI have switches that might activate the drive?

TY
Ray


Bus 1 (PCI), Device Number 10, Device Function 3
  Vendor 1180h Ricoh Co Ltd
  Device 0576h SD Bus Host Adapter
  Command 0102h (Memory Access, System Errors)
  Status 0210h (Has Capabilities List, Medium Timing)
  Revision 01h, Header Type 80h, Bus Latency Timer 00h
  Self test 00h (Self test not supported)
  PCI Class System, type Other
  Subsystem ID 125610CFh Unknown
  Subsystem Vendor 10CFh Fujitsu Ltd
  Address 0 is a Memory Address (0-4GiB) : D0200800h..D02008FFh
  System IRQ 11, INT# D
  New Capabilities List Present:
    Power Management Capability, Version 1.1
      Supports low power State D1
      Supports low power State D2
      Supports PME# signalling from mode(s) D0, D1, D2, D3hot, D3cold
      PME# signalling is currently disabled
      3.3v AUX Current required : 0 mA (Self powered)
      Current Power State : D0 (Device operational, no power saving)
        720 mW D0 power consume
        720 mW D0 power dissipate
        640 mW D1 power consume
        640 mW D1 power dissipate
         10 mW D2 power consume
         10 mW D2 power dissipate
         10 mW D3 power consume
         10 mW D3 power dissipate
          0 mW common logic power consume

  Bus 1 (PCI), Device Number 10, Device Function 4
  Vendor 1180h Ricoh Co Ltd
  Device 0592h Memory Stick Bus Host Adapter
  Command 0102h (Memory Access, System Errors)
  Status 0210h (Has Capabilities List, Medium Timing)
  Revision 00h, Header Type 80h, Bus Latency Timer 00h
  Self test 00h (Self test not supported)
  PCI Class System, type Other
  Subsystem ID 125710CFh Unknown
  Subsystem Vendor 10CFh Fujitsu Ltd
  Address 0 is a Memory Address (0-4GiB) : D0200C00h..D0200CFFh
  System IRQ 11, INT# D
  New Capabilities List Present:
    Power Management Capability, Version 1.1
      Supports low power State D1
      Supports low power State D2
      Supports PME# signalling from mode(s) D0, D1, D2, D3hot, D3cold
      PME# signalling is currently disabled
      3.3v AUX Current required : 0 mA (Self powered)
      Current Power State : D0 (Device operational, no power saving)
        720 mW D0 power consume
        720 mW D0 power dissipate
        640 mW D1 power consume
        640 mW D1 power dissipate
         10 mW D2 power consume
         10 mW D2 power dissipate
         10 mW D3 power consume
         10 mW D3 power dissipate
          0 mW common logic power consume


 
Yahoo! Groups Links

 To visit your group on the web, go to:
    http://groups.yahoo.com/group/os2hardware/

 To unsubscribe from this group, send an email to:
    os2hardware-unsubscribe{at}yahoogroups.com

 Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 



---