Re: Re: Working with QICO
  By: Nick Andre to Deon George on Thu Apr 30 2020 10:30 am

 NA> As per my other message - Is this running on a dialup modem or a
 NA> virtualized/telnet session. And have you tried the FTS-0001 and Wazoo
 NA> overrides in Config-Advanced-Security/Misc. Those questions allow you to
 NA> force the use of alternative protocols in the initial handshake.

So this is DB running in dosemu - using tcpser.

I have played with those two settings - with mixed results.

I turned them both off and tried again, and a bit further:

01 May 20 12:53:52 tcpip[28460]: starting inbound EMSI session
01 May 20 12:53:52 tcpip[28460]: address: 10:2/2@private
01 May 20 12:53:52 tcpip[28460]:  system: (null)
01 May 20 12:53:52 tcpip[28460]:    from: (null)
01 May 20 12:53:52 tcpip[28460]:   sysop: (null)
01 May 20 12:53:52 tcpip[28460]:   phone: (null)
01 May 20 12:53:52 tcpip[28460]:   flags: [0] (null)
01 May 20 12:53:52 tcpip[28460]:  mailer: D'Bridge 4/XMIT
01 May 20 12:53:52 tcpip[28460]:    time: 00:00:00, unknown
01 May 20 12:54:51 tcpip[28460]: total: 0:00:00 online, 0b sent, 0b received
01 May 20 12:54:51 tcpip[28460]: session with 10:2/2 failed [ok]

DB reported:
05/01/2020 12:53  Calling 10:1/1 at 57600 baud
05/01/2020 12:53  Modem reports "CONNECT 38400"
05/01/2020 12:53  EMSI: 10:1/1, qico 0.59.1
05/01/2020 12:54  Z16-S: Fatal timeout, aborted
05/01/2020 12:54  Successful, 01:14, a "free" call

But let me play a bit more and see what I can figure out.
...лое


... That must be wonderful!  I don't understand it at all.
--- SBBSecho 3.10-Linux