RB>> I am using the Domestic 1 Nov 95 code and It will soon be Hacked and

 RB>> released as the Austel Code no Doubt, But you cant wait that long , can

 RB>> you. 

 RB>> The 1 Nov code lets you disable the TX level Deviation (letting you

 RB>> lock it at  -10dB, if you want) and that is what the Austel model

 RB>> lacks. 





 JB> Russell old pal.... Tell me more about this Domestic 1 Nov 95 code and 

 JB> how I



Well Jesse, You can GET it, Poe has it, But I doubt it will load into your

Austel Modem. (you could try to though, It can only tell you if it won't load)

It is intended for the Domestic Courier (US/Canada originaaale version)



 JB> can get it.  I'm useing the July 95 Austel code.  Is this code
"the good 

 JB> oil" what?.



The good oil For the Austel version at the moment is to forget the Austel

nobbled 18July/5July SDL and return to the 5July/5July SDL.



If, who ever controls the rewritting of the below US/Canada code for

Austel, gets off their butoozla's, then soon this will be available for

Australian Couriers. It has been released for 3 & a bit months now.

Australian Appathy strikes again.





        11/1/95 Courier V.Everything Release Notes - changes since 7/5/95 

        =================================================================



        DSP Date : 10/16/95

        SV Date  : 11/1/95



New Features/Improvements



1.  V.34 leased line (&L1) mode supported.  If V.34 is disabled, 

    then leased-line mode works as it has in the past.



2.  Added S55 bit 7 to control Phase Roll Compensation.  This allows

    better connect rates when operating on lines with asymmetrical frequency 

    offset.  It is intended primarily for testing.



    Setting S55 bit 7 = 1 will enable Phase Roll Compensation, default is 

    disabled.   Note that this will _reduce_ performance if used on lines 

    that do not suffer from this type of impairment.



3.  Added 3 new fields to the ATI11 screen:  Near echo, Far echo, and

    Signal to Noise Ratio.



4.  Improved handling of inbound BREAK signal when Remote Access feature

    is enabled.



5.  Corrected V.34+ result codes when used with &A0.



========================================================================== 

Known Issues



1.  Modem may need to have dip switches configured as follows in order to

    flash to previous firmware:



Externals                   Internals



 1   ON                      1   ON

 5   ON                      5   ON

 7   ON

 8   OFF                     8   OFF

10   ON



Dip switches not listed can be set in either position.



 JB> Talk later,



Yes, Must get back to the case at hand....Paul Edwards



 JB> Jesse



Russell





--- Terminate 3.00/Pro