-=> Quoting Bro Mcleod to All <=-
-=> FidoMail to 1:163/215, please.-=<
bm> I wonder if I could get some help on my new Ellcon 28800. I,m
bm> having trouble getting carriers better than 19200. Some bbs,s
bm> are ok and others only to 19200. Games are fine also. I have a
bm> Rockwell chip set and use Pro comm Plus. I have Re-Written the
bm> s-regesters to the best I can as The Manual INT strings wont
bm> work.. I'm also using a serial driver up to 115600 and am sure
bm> the prob is not there. My int string is as follows
bm> AT&Y1&R0&K3%C0\N3\G0^M THE (&Y1) is to poke my settings witch
bm> are mostly set to default but include a routine to dial
bm> out-ATX3DT... If anyone can help or have the same modem I,d love
bm> to hear from you..Thanks.. 
I'm not sure about the &Y1.  The _normal_ procedure is to configure
the modem starting with a set of factory defaults (&Fn) and then
adding to that specific commands that differ from the defaults,
ending with &W to save that configuration to a profile.  The actual
init is then done with ATZ.
The X3 command and the T command (for Tone dial) are usually included
as part of that configuration.  I'd expect a string such as
AT&F &C1 &D2 &R0 &K3 %C2 \N3 \G0 T X3 &W ^M
as the configuration string, and then ATZ as the init that would be
used.  Note I've suggested %C2 for V.42bis data compression rather
than no compression at all.
Make sure your port is locked at least at 57,600 bps.
TTFN. Rick.
Ottawa, ON 9 Mar 1:56 
--- Blue Wave/DOS v2.20
---------------