CR>Russ:
CR>        It helps to READ the manual.  I just checked my manual (10/1/92
   Charles, I do READ ALL the manuals I have.  Most likely more than
most folks as I usually read a new product two to three times before I
even attempt to install/use it.
CR>Printing) on page 63, under System, and it says that this down arrow
                     ^^
   Well mine was printed 9-1-94 and that would put my in terminal screen
section.
CR>contains a listing of the Manual Dial history List.  It's purpose is the
                             ^^^^^^^^^^^
   Your are correct in this.
CR>numbers.  As I said in my previous message, Don't use the Down Arrow and
   Charles after using the information about the manual dial history and
the system entry I was able to track it down in my manual and even then
the information they give is so limited that one would just have to be
lucky to run across it and understand just what they are referring to.
   Had I simply remember to hit he F1 key after hitting the down arrow
all would have been explained.  After this was pointed out to me by Bob
Seaborn I follow his suggestions and walla my answer was forthcoming
at the press of a key.
  I was still a bit ticked at not being able to find the information I
was looking for in my manual and I was able to find it albeit it is
very sparse and hard to locate I would thank you for your help.
  Russ
---
 * QMPro 1.53 * CCITT- Can't Conceive Intelligent Thoughts Today
--- QScan/PCB v1.19b / 01-0162
---------------