PE> I will be dropping down from 57600 before too long, in an attempt
PE> to see if that has a bearing on the Zmodem errors I see occasionally
PE> on EC connects.  Since I have a decent modem, I only need change
PE> the software, autobaud does the rest.  I'm not even sure what 
PE> speed I did the last AT&W at on the Netcomm, I think it was 57600
PE> though, but I don't actually care (I don't need to care, I've got
PE> a modem that autobauds properly).

If you're still running the Netcomm, you'll probably get better performance
at 38400.  They've always had trouble with higher speeds.  (It may now be
fixed - we may also get high altitude bombing runs from herds of
Poland-China hogs..)

Matter of fact, this may suffice to clear your errors.  Never mind that it
takes a percent or two off the rate - the average throughput is better
without the retries.

 Dave Hatch

--- Msgedsq 3.20