RE> I'm using Xenia so I guess the MCP option is out.
 RE> I tried the SM.EXE and it shows three lines, all {off 
 RE> line}, even with two people logged on locally.
 RE> Does it only monitor actual modem lines?
SM will monitor however many lines you have setup. Maximus loads the MCP 
server whenever it starts. Since i run bink xe, and it has an mcp interface, 
i load mcp in hte config.sys (there's instructions to do it in the max.doc, 
it says for a network but you can load it anyways) and through SM i can see 
what bink is doing anywhere on the system. I can also see if someone logs on.
Go through your max.ctl and make sure all the mcp stuff for os2 is setup 
properly.
--- Maximus/2 3.01
---------------