Message-ID: 
Newsgroups: AIRGUN.LIST
The performance I have been able to get from the  TLD200 pcp so far is
this.   2200 psi.   3 shots at 797,818, 837, then 31 usable 865 low, 924
high. pressure went from 2200 down to 1200. I am using a stock valve
spring, I think I need to heavy it up a bit.   Yesterday, I had a heavy
valve spring in, bolt spring was cranked all the way up, I got 51 shots
between 736, and 789.  I personally like the latter as the way to go, and
only changed because the bolt spring had to be cranked in all the way, I
felt that it could be hard on the gun as it was hard to cock. Anyone have
any input to this? I am not sure of the way to go for the most consistent
shots per charge. Is this just a fiddlin thing, or are there hard and fast
rules about the relationship between valve spring bolt/hammer spring
combos?  BTW I believe that a few shots above 1000 fps could be gotten.
Also, all tests were done with lubed lights  Thanks, Mike
--- QScan/PCB v1.19b / 01-0671
---------------