From: shadow{at}shadowgard.com

On 13 Jan 2005 at 9:53, da Silva, Joe wrote:

> That's just as well, since I don't have any software for configuring
> NE2000 clone boards, anyway.   
> 
> Actually, I was able to figure out the IRQ jumper settings by doing a
> bit of circuit tracing. The the I/O address and Boot ROM jumper
> settings (and the type of card) I figured out by trial-and-error with
> NE*.COM packet drivers (which are very convenient for this purpose,
> since they take their parameters from the command line, rather than a
> configuration file).

I've got a chart of the jumpers around here somewhere (because I have 
a couple dozen NE100 cards I "inherited".


--
Leonard Erickson (aka shadow)
shadow at shadowgard dot com




--- Internet Rex 2.29