In , on 11/21/07
   at 10:29 PM, Jim Byrnes  said:

Hi,

>I was able to install ecs on D: and then reboot and install Backagian/2 
>on E:.  When I ran BA/2 I got a message that there was no tape drive 
>present.  I opened the case and saw that I must have bumped the scsi 
>cable as it was not attached to the tape drive.  I shutdown and plugged 
>the tape drive back in but when I tried to reboot I got a message that 
>there was no boot drive.

This could be a drive enumeration issue.  Since you want to boot from the
SATA drive, make sure danis506 preceeds the SCSI .add driver.

You might need to configure the SCSI card to not load the SCSI BIOS.

Finally check the MB BIOS settings.  They all seem have a different set of
options to select alternate boot devices.

Steven

-- 
----------------------------------------------------------------------
"Steven Levine"   MR2/ICE 3.00 beta
09pre #10183 eCS/Warp/DIY/14.103a_W4 etc.
www.scoug.com irc.ca.webbnet.info #scoug (Wed 7pm PST)
----------------------------------------------------------------------



 
Yahoo! Groups Links

 To visit your group on the web, go to:
    http://groups.yahoo.com/group/os2hardware/

 Your email settings:
    Individual Email | Traditional

 To change settings online go to:
    http://groups.yahoo.com/group/os2hardware/join
    (Yahoo! ID required)

 To change settings via email:
    mailto:os2hardware-digest{at}yahoogroups.com 
    mailto:os2hardware-fullfeatured{at}yahoogroups.com

 To unsubscribe from this group, send an email to:
    os2hardware-unsubscribe{at}yahoogroups.com

 Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 

---