Hi John,
Thanks for the info but I'm not sure I understand  the init strings you
     supplied.  Would the factory defaults have to be restored before the
     ones you gave were used or would an entire new string have to be sent
     to the modem first?  If an entire new string was needed to be sent
      do you know what that would be?  The problem is that we have no idea
     what the present setup is and so was seeking a complete new string
     which could be saved to the modem.
     Nev

JC> NM> I am looking for an init string or strings for a BBS I am helping to
JC> NM> maintain.  I am running Binkleyterm 2.56 as the frontend and Maximus
JC> NM> 2.02 as the bbs software.

JC>Tell David he would be better setting up the current
JC>versions of Binkleyterm (v2.60) and Maximus (v3.01).

JC> NM>  I am using a Netcom SmartModem M7M as the modem.

JC>I suspect the modem may really be an M7F.

JC>The profiles I have used here are below.  Set up your
JC>modem's profile as below and save it to non-volatile RAM
JC>using the AT&W command.  The init string for Binkleyterm
JC>then becomes ATZ|.  Set the init string for Max to ATZ as
JC>well but this will not be used if using BBSBatch or
JC>SpawnBBS hand over methods.

JC>Set up Binkleyterm to hand over to Maximus using the
JC>BBSBatch method if using DOS or SpawnBBS method if using
JC>OS/2 - sample bat/cmd files are described in the docs.

JC>Regards ... John

___
 X OLX 2.1 TD X Back Up My Hard Drive? I Can't Find The Reverse Switch!

--- Maximus/2 3.01