This message was originally addressed to ALL
and a carbon copy was sent to you.
                    ----------------------------------------
Me and my Dad recently switched some systems around.  In the process we
moved a hard drive with Qmpro for Windows 1.01 from a CompuAdd 320 to a
CompuAdd 325 with both systems being DXs.  After the switch I
modified the 325 to use a Tens (SP?) 800x600 Small driver on a CompuAdd
High Res Windows driver disk we have in place of the Windows VGA
previously installed on the hard drive.  The the 320 had supported only
low res drivers, but the 325 did and I wanted to use one.  Today I
upgraded the Qmpro for Windows to 1.11b using the 1.10 and 1.11b
patches from the Mustang HQ. When loading it to make sure it was at
1.11b I noticed that unlike on a 486/DX 66 we have with a TRIDENT
800x600-256c for 1M Board (Faster) driver there was no pattern visible as
with the VGA driver.  I would like to have the patter visible.  Any ideas
on how to make the Windows size the right size for this driver so I can
see the pattern?
Thanks,
Lila Godel
cc: ALL
    ALL
---
 þ OLXWin 1.00 þ (A)bort, (R)etry, (S)mack the @#$&*~ thing!
--- WILDMAIL!/WC v4.12 
---------------