Hi Steven,

 DH> I'm not running XR6, Steven, but as a kludge how about running a
 DH> util like FU or GREP to strip out the lines which cause problems
 DH> (or to build a new log with just the lines you want to analyze) and
 DH> then run BinkLa??

 SH> I'm not sure which lines create problems and I did try
 SH> stripping everything but an actual connection but still had
 SH> the same unsatisfactory result.  As good as the "new" Bink
 SH> is, I'm tempted to revert.

It's been a while since I cared  but I recall Bob publishing
the full source in some sorta BASIC or other, and it might be easy enough
to modify for any new lines that are giving it pain?  A lot of messages
have changed, some only a bit, but the major changes are perhaps in terms
of upper/lower case?

Sorry, I never could bring myself to hack BASIC code again, not after '81 :-)

Still running BinkLA 1.05 (yes!) with Bink 2.60, and while it misses out on
doing the cost reports, I'm now doing far too little traffic to mind.

Cheers, Ian

--- MaltEd 1.0.b5