Hi Harry,

 HO> what do I put in the route.cfg to make all the mail 
 HO> i want to send to my up link? I have the following

 HO> route Hold 3:690/650  3:690/650/all
 HO> Send crash 3:690/650/All

Not a lot of detail, but assuming YOUR node is 3:690/416 and you want to
route all your OUTBOUND MAIL via 3:690/650, then I would use something like
this in my regular scan/pack event -

    ROUTE HOLD 3:690/650 World

Which captures EVERYTHING leaving your system and places it on hold for 3:690/650.

Then if you wish to actually deliver that mail to that system at a later
time, use an event that contains -

    CHANGE HOLD CRASH 3:690/650

This changes any HELD mail for the destination system to CRASH. These are
the basic routing lines you would need to start with.

PS: This would probably be better in the SQUISH Echo, rather than BINKLEY.

I hope this helps..........pk.


--- Maximus/2 3.01