From: Chris Plicht 
To: atm{at}shore.net
Reply-To: Chris Plicht 


James,

our glass pushing group meets on Thursdays, so I'll show the screenshot
around tonight and pass on
any comments. Well, probably too late for any major suggestions, but I
think there is little to be
asked for. Thank you for your effort.

However, one thing would be desirable for many Europen users: give the
radius, beside the %, in
cm. In addition to use SI units it makes sense since you employ nm for the
surface error scale,
not fractions of an inch.

Would it be possible to alter this radius data based on the input in screen
 'Measurement
units'?

Just my 0.02 cent (Euro)
Chris

--- BBBS/NT v4.00 MP