MG> PM>MG> 2: The CONNECT XXXXX (like connect 26400) on my end is often
MG> PM>MG> not the same as the remote side.. Like my end will say I
MG> PM>MG> connected at 24000 and the other will say 26400.. Is there
MG> PM>MG> any way to fix this?
MG> PM> Its not "broken", so you can't fix it. :-)
MG> PM> In V.34 mode the modems have the ability to use different
MG> PM> carrier rates in each direction...rather than using the best
MG> PM> carrier rate the lower quality signal path can support.
MG>I don't really understand what you mean, but oh well..
        Okay, let me try again.
        The max. stable carrier from Your modem to the Remote is
        say 26.4k
        Due to telco problems the max. stable carrier from the Remote
        to your modem is say 19.2k.
        Would you rather transfer data in BOTH directions at 19.2k
        or would you rather have 26.4k to the remote and 19.2k from
        the remote (in this case your uploads would be MUCH faster)?
MG> PM> If you really want to disable this you can by setting S210=5
MG>You make it sound like it's bad when both sides display the same baud
MG>rate.. Why's that?
        Only for best performance (see above).
MG>Oh, and how come that isn't listed in the manual?
        See the 336_LIST.TXT doc in a few days on Supra BBS (if
        it isn't covered in the current V34_LIST.TXT file).
CMPQwk1.42 331ūStart init. strings with AT&Fn for solid configurations
--- FLAME v1.1
---------------