PM>MG> 1: Say I call one BBS, and it's busy, I hit escape and dial another
 PM>MG> one right away, it takes approx 5 seconds before it'll start dialing
 PM>MG> again.. (This is not a prob with my software.. It already starts
 PM>MG> counting the dialing time and has issued the ATDT command when it's
 PM>MG> paused)
 PM>MG> Is there a way to make it so it'll start re dialing right away like
 PM>MG> my USR 14.4 did??
 PM> Technically in North America, that forced minimum delay between
 PM> calls is supposed to be there.
But it's annoying... Is there anyway to make it so that it'll start dialing 
right away?
 PM>MG> 2: The CONNECT XXXXX (like connect 26400) on my end is often not the
 PM>MG> same as the remote side.. Like my end will say I connected at 24000
 PM>MG> and the other will say 26400.. Is there any way to fix this?
 PM> Its not "broken", so you can't fix it. :-)
 PM> In V.34 mode the modems have the ability to use different carrier
 PM> rates in each direction...rather than using the best carrier rate
 PM> the lower quality signal path can support.
I don't really understand what you mean, but oh well..
 PM> If you really want to disable this you can by setting S210=5
You make it sound like it's bad when both sides display the same baud rate.. 
Why's that?
Oh, and how come that isn't listed in the manual?
cya
--- FMail 1.0g
---------------