To: "Scott Berfield" 
From: Scott Rychnovsky 
Cc: atm{at}shore.net
Reply-To: Scott Rychnovsky 


Scott,

I take the other approach.  most of my pitch tools are aluminum or plaster.
 The aluminum ones are slippery and a pain to hold.  I paint them with
refrigerator epoxy spray paint, which makes them even more slippery but
easier to clean.  I then apply no-skid strips to the sides and the tops in
a pleasing pattern.  This is the same "tape" that you might put
down in a bath tube or around a pool.  Now the tool is easy to hold and I
can pick it up without dropping it on the mirror and taking a chunk out of
the edge.

Scott
--
--
Scott Rychnovsky
srychnov{at}chem.ps.uci.edu
ATM Page: http://tlepage.home.mindspring.com/

--- BBBS/NT v4.00 MP