From: "Richard Schwartz" 
To: 
Reply-To: "Richard Schwartz" 



----- Original Message -----
From: "Russell Jocoy" 
To: 
Sent: Tuesday, April 15, 2003 8:07 PM Subject: ATM Progress on 9" and 10" x
5/8" mirrors


>
> ("atm{at}shore.net")
>
>
>          Just a little note on my progress after being idle for a few
> months.  After polishing thru 5 micron
> and pleased with the surface, I decided to experiment with something I
read
> on this website.....

I never heard of polishing with 5 micron.   Normally you grind with that
stuff.

> Uh Oh, you in trouble now...  I bought some felt 8x10 sheets at the
> wal-store and washed and dried
> them .  I then sprayed 3m contact cement on the surface of my existing
tool
> and felt sheet.

Just before you bought that felt, a store clerk dropped it on the floor where
akid had tracked in mud from the local #60 silicon carbide mine.

If you think felt polishes good, you should try pitch.   I am in the middle
of two 9 inchers, and I consider the 4 hours I did on felt to be a waste of
time.  The best thing you can do to speed up polishing is an extra hour of
GRINDING with 5 micron grit.

. . . Richard

--- BBBS/NT v4.00 MP
 - 0rigin: Email Gate (1:379/1.100)

 - 0rigin: MoonDog BBS, Brooklyn,NY, 718 692-2498, 1:278/230 (900:100/50)