From: "Aditya Munshi" 
To: 
Reply-To: "Aditya Munshi" 


The diagonal minor axis is 40mm, tube Outside dia is 150mm inside dia is
243mm, and the material is plate glass.




Thanks

Aditya






-----Original Message-----
From: owner-atm{at}shore.net [mailto:owner-atm{at}shore.net] On Behalf Of
waldo kitty
Sent: Thursday, June 19, 2003 3:59 AM To: mdholm{at}telerama.com; atm{at}shore.net
Subject: Re: ATM Mirror Cell Help


mdholm{at}telerama.com wrote:

> Adita,
>
> Please send your planned diagonal mirror minor axis.  That is one of
the
> variables Plop uses.  It isn't absolutely necessary, but helps.
>
> I will run out a couple of designs for you and send the dimensions.

i just posted a few for adita and look forward to your comments...

> Based on previous examples (see
> http://www.telerama.com/~mdholm/atm/cells/index.html ), a 3-point cell
will not
> be good enough for this mirror.  You will need at least 4 and perhaps
6 support
> points.  More than 6 will not be required.

based on my runs with plop, i agree... a 6 point should do quite well...
the 18 pointer i posted would be an interesting excercise in workmanship
and machining capabilities >  i found it kind of odd that
the 9 point was worse than the 6, though...

--
        _\/
       ({at}{at})                      Waldo Kitty, Waldo's Place USA
__ooO_( )_Ooo_____________________ telnet://bbs.wpusa.dynip.com
_|_____|_____|_____|_____|_____|_____ http://www.wpusa.dynip.com
____|_____|_____|_____|_____|_____|_____ ftp://ftp.wpusa.dynip.com
_|_Eat_SPAM_to_email_me!_YUM!__|_____|_____ wkitty42 -at- alltel.net

--- BBBS/NT v4.01 Flag-4