PC> G'day Ronald
 
 RC> I have a netcomm 28.8 running under Windows 3.11 and Telix for
 RC> Windows I have had the same problem but it seem to be the baud
 RC> rate went you  setup for a BBs  I have had to change it a few
 RC> times but mine works  fine now.
 
 RC> When I install telix auto detect, Detected a Zoom Modem 28.8.k
 RC> and that  is what I use string are AT&F^M~~ATZ0~~AT%C%E2^M

 PC> I'm not sure of the command set the roadster uses as i've only owned
 PC> Smartmodems but your string above seems strange, see my breakdown
 PC> below.

 PC> AT&F^M    ; recall factory defaults
 PC> ATZ0      ; recall saved profile 0, note this distroys the settings
 PC> ; that the AT&F line above setup.
 PC> AT%C      ; turn off compression
 PC> AT%E2     ; enable speed stepping.

 PC> Why not try in a terminal just once...

 PC> AT&F                ; recall factory defaults
 PC> AT&C1&D2&K3S0=0&W   ; change a few settings and save to NVRAM

 PC> now just use ATZ when you want to reset the modem.

 PC> Pete.
 
Hi Pete

Thanks for the note I see what you are saying about the init strings.
My problem was I got a new Netcomm Roadster 288 and also got Cooee 
software with it when I set up the program and the Modem all I could get
was Baud rates of 9600 to 14000.

I got on to Netcomm and was given new init strings but that did not 
improve things, I then tried a number of Init strings and that did
not improve.

to cut a long story short when I got Telix for windows it auto detected 
the Zomm Modem and the init strings and I started getting connect rates 
between 21000 and 26000 so I just stuck with the above strings and 
decided to let it keep going the way it is.

Copied your messsage and will keep it just in case things go wrong.



 PC> -!- OMX/Blue Wave v2.12
 PC>  ! Origin: Gates of Hell (3:713/914.16)



... Not tonight, dear.  I have a modem.

___ Blue Wave/QWK v2.20

--- Maximus/2 3.00