Hello Rick.

17 Nov 20 14:50, you wrote to me:

 KN>> REM SIO Setup
 KN>> DEVICE=c:\sio\sio.sys (COM1:115200,INTERNET:3F8,4,-)
 KN>> (COM2:115200,INTERNET:2F8,3,-) (COM3:115200,INTERNET:3E8,4,-)
 KN>> (COM4:115200,INTERNET:2E8,3,-)
 KN>> DEVICE=c:\sio\vsio.sys
 KN>> DEVICE=c:\sio\vx00.sys

 RS> Thankyou for that... I did try your config lines with vsio2k and
 RS> crashed system... So I installed 160 and it seems to boot fine and
 RS> claims to be running... when I run vmodem from a command prompt it
 RS> loads and says that it is fine.. So setting those com ports to
 RS> "internet" is that the only variable? Is there no where to mention
 RS> telnet and perhaps a port? or does it just listen for any traffic?  So
 RS> far I can get it to react to an incoming telnet....

It should automagically grab port 23 and the first connection will connect it
to COM1, and if another connection comes it it goes to COM2, etc.

Vmodem should load with 4 lines on top for each of the com ports. And when
someone attempts to connect to the port, it should show the incoming connection
 below that. It shows the IP and the port it is assigned to.

Is it showing any of that?

Kevin

--- GoldED+/EMX 1.1.4.7