MBl>>> I'm not familiar with the ISDN modems. More info might help 
MBl>>> evaluate whether it's possible/practical to disable the CD 
MBl>>> routines.

MBi>>> This sounds like a job for a piece of wire.

MB>> If you need DCD asserted, wire the pin to whichever other pin is 
MB>> convenient.

DH>> That's a bit difficult across an ethernet cable.  The ISDN
DH>> setups I have operate via Cisco 1003 routers.  The function
DH>> exists - but it's "different". 

MB> Why are you using the dialer at all, then?

Because that's the only way to coax the Cisco to connect at ISDN.

No dial, no connect.

DH>> "Transport" needs to be handled in a pretty generic way if
DH>> it's to survive in all of the Modem/Cable
DH>> modem/ISDN/T1/EtherNet environments.  So does node
DH>> addressing.  Workin' on it.

MB> Maybe I'm not following what it is that you are doing?

At the moment, trying to understand / make use of the potential on ISDN
interfaced Cisco 1003's.   Watch this space, there will be further
developments after this primary task completes...:-)

Regards,
Dave Hatch.

--- Msgedsq 3.20