Hello Allen.

23 Dec 07 13:41, you wrote to all:

 AP> Anyone know how to set the DIP switches on a courier v.everything to
 AP> factory default?

    The default setting for the is DIP switches is 3, 5, 8, and 9 are
ON (in the down position). While DIP switches 1, 2, 4, 6, 7, and 10
are OFF.


To do this set DIP Switch's to one of the following:

Set DTR to Normal.......................... 1 OFF (Default)
Ignore DTR................................. 1 ON

Set verbal result code display............. 2 OFF (Default)
Set numeric result code display............ 2 ON

Disable result codes....................... 3 OFF
Enable result codes........................ 3 ON (Default)

Enable the echo in offline commands........ 4 OFF (Default)
Disable the echo in offline commands....... 4 ON

Enable auto answer......................... 5 OFF
Disable auto answer........................ 5 ON (Default)

Normal Carrier Detect...................... 6 OFF (Default)
Carrier Detect always on .................. 6 ON

Display result codes in ALL modes.......... 7 OFF (Default)
Display result codes in originate mode only 7 ON

Disable AT commands........................ 8 OFF
Enable AT commands......................... 8 ON (Default)

Disconnect on escape (+++)................. 9 OFF
Online command mode on escape (+++)........ 9 ON (Default)

Load configuration stored NVRAM............ 10 OFF (Default)
Load &F0 configuration (ROM)............... 10 ON


Hope this helps.


 AP> Allen

 AP> --- SBBSecho 2.11-Win32
 AP> (1:2320/100)

Jeff

--- GoldED+/W32-MINGW 1.1.5-b20070503