92b50001
From: Michael Wilkes 
Please do not take offense since I am not quite sure what you are
saying, but to mark a number of lines, press whatever key is defined as
markline() at the beginning of the block(line 32)(I am guessing in your
case this is alt-I). Move to the end of the block (line 35) and press
this key again. Now the block is marked, and it doesn't matter where you
move the cursor, the block from 32-35 will remain marked. 
You can now move to the location you want to move the lines, and press
your move key. If you want to unmark the block, use Unmark. These
commands also appear on the Block menu.
HTH
> -----Original Message-----
> From:	Curtis Delzer [SMTP:curtis@calweb.com]
> Sent:	Friday, February 20, 1998 6:24 PM
> To:	tsepro@semware.com
> Subject:	marking end of block.
> 
> 
> 
> This is elementary, I am sure, however in my general setup of TSE, if
> I
> use the alt-l to mark a line and keep going down to the end of what I
> want to mark, How do I do that?  Here's what I mean; I want to mark
> lines at the bottom of the text, 32 through 35 for example, then move
> them up to 1 through 3.  I know how to use alt-l and go down from 32
> to
> 35, use alt-m to move the block after I have the cursor in the place I
> wish to put the text, but if I go to the end, then go back up,
> probably
> the mark would get lost.  It is marking the end I don't know, in
> Tsepro's
> generic configuration.  If I mark a paragraph, the mark would just go
> down to the first blank line after I started and stop and then, the
> end
> would be marked, but that isn't what I need to do.
> 
> Any help gratefully appreciated.  In Q-Edit, I could "mark beginning,"
> and "mark end" and then do whatever I desired with the block but this
> function isn't burned into the generic configuration that I could
> find,
> or I am totally missing something, which is entirely likely. :^)
> Thanks!
> 
> Curtis Delzer,  H.S.,    WB6HEF,    Sacramento, CA.
> curtis@calweb.com
> 
> When in doubt stop thinking and all doubt will go away.
> 
> Net-Tamer V 1.11 Beta  - Registered
---
---------------