Hello, Ian....
 
 IM> Roger, are ya still by lad?
 Yeah, I'm still here...took a few weeks on several trips...missed the
 flying (durnit) !
 IM> When you wrap a wing or tail in film where do you leave the edge?
 IM> I'm doing a repair and normally i bury the joint at the hinge points.
 IM> This time round that area is unaccessable because tail assembly is
 IM> intact and I have only had to rebuild the rudder.  The hinges are
 IM> pined and inplace. 
 My suggestion is to slit (slot ??) the film and poke it through the hinge
 line from the bottom so that the "poked-through" portions can be anchored
 down on the top side of the surface - then overlap the film covering on 
 the surface top so that it covers the sealed-down film portions extending
 from the bottom.  This is the way I re-cover after repairs when I can't
 remove the hinges - frequently the hinges are stressed or damaged, then I
 cut them out and replace them.  Is my explanation clear ???  Good luck.
 BTW, why the repairs ????  TTYL - Roger
... Catch the Blue Wave!
--- Blue Wave v2.12 [NR]
---------------