On 15 Nov 2024, Dennis Slagers said the following...

 DS> However .. the issue I have here when I succeed and I found that just
 DS> out is: when a point is being mailed by me and I accidently add an Cra
 DS> or Imm / Dir flag .. it stays in my outbound
 DS> and it is not send crash delivered to their boss ..
 DS> 
 DS> Is there a setting for?

You could do something like:

# If $fromaddr is not a point
if ( $fromaddr !~ /\./ || $fromaddr =~ /\.0$/ ) {
    $direct = "\x01FLAGS DIR IMM\r";
}

# Prepend kludge lines
$msgtext = "\x01MSGID: $myaddr $mid\r\x01TZUTC: $tz\r".$direct.$msgtext;

This should only add the FLAGS kludge if you get a message from node (e.g. 1:229/664 or 1:229/664.0).  If it's a point address the kludge is not added and should be sent routed.


You could also try adding:

else {
    $direct = "\x01FLAGS HUB\r";
}

To the bottom of the above if statement and the message *should* be routed through the host or hub.  I've never tried/used this flag so I'm not sure how well (or if) it works.


http://ftsc.org/docs/fsc-0053.002

HUB:
Host- or Hub-route message (as appropriate).

DIR:
Message must be sent directly to its destination and may not be routed.

IMM:
NOW!-priority mail. Send at first opportunity, override any transmission restrictions enforced by events, costs, or qualification.


Jay

... I stayed up all night to see where the sun went. Then it dawned on me

--- Mystic BBS v1.12 A49 2024/05/29 (Linux/64)