I have been using Qmodem TestDrive 4.52 since I started modeming.  It
  has been a great program for me, and I even returned a commercial
  program that did not work as well (and ate the shipping costs).
  Lately I have been having a problem that might just be inherent in the
  program, or it might be that I do not have something set right.
  The primary BBS I use recently made some major changes (in phone lines
  and in BBS software) and ever since then, I have been getting errors
  on downloads with some degree of regularity.  That would not be so bad
  if Qmodem would recover from the errors as I think it is supposed to.
  What happens is
  CRC error,
  Sending ZRPOS
  perhaps a few other error messages, but then a total freeze.  Only
  hitting the ESC key to cancel has any effect.
  It does not handle restart / overwrite of file at all either, same
  effect if I try of several cycles of error messages, and then freeze.
  I am using SIO com drivers with OS/2 Warp 3.0, at FP26.
  Some of the toggle settings:
  Xon/Xoff flow        OFF
  CTS/RTS flow         ON
  RTS when Writing     OFF
  FIFO during Shell    ON
  Lock DTE Baud Rate   ON
  High Speed Xmit      ON
  16550 UART Enable    ON
  Init ignores CD      OFF
   -- and under Options, runtime parms
  EMS for Overlays    OFF
  Int16 Enable        ON
  Share IRQ's         OFF
  Optimum Shell       ON
  -- Disk Shell       ON
  Calibrate DELAY     OFF
   I have read (and re read ) the DOC file on these settings and
   twiddled around with those I am not sure of.
   I have a USR Sportster 28800, and speed is set at 57600.
   Any assistance would be greatly appreciated.
                             dale@mbbs.com
                            (1:261/1137.11)
... Shipwrecked on Hesperus in Columbia, Maryland. 01:22:16 31 Aug 97
___ Blue Wave/DOS v2.30
--- Platinum Xpress/Win/Wildcat5! v2.0
---------------