I seem to be having a problem all of a sudden and am looking for some help. I 
am using version 1.53 (DOS) of QModemPro, and have been for several years. 
Now all of a sudden, when I try to swap out to DOS from within the program, 
(Alt-R) or swap into OLX, the Offline Reader (Alt-M), I get an "Unable to 
Swap to Disk" message.  It worked fine up until about two weeks ago so I 
don't know what is going on.  I can force it work work if I exit the program 
(Alt-x) and come back in.
I looked at the Help file and it says that it should work if you have your 
Comspec=Command.com in the Autoexec.bat.  I checked and the command is there 
first thing so I am not sure what is going on.
Suggestions?
I could go the route of deleting the program from my hard disk and resetting 
it up, but that is a long process.  I have to go the whole way back to 
version 1.0 and put in all the patches to get back to 1.53, over an hours 
worth of work.
I just found another error too.  I tried to enter this message from within 
OLX after exiting and coming back in and it did not save it when I left the 
MailReader.  I am starting to think I need to just dump what I have on my 
disk and reset up the program.  I will hold off though for a few days until I 
see if any of you have any suggestions.
... "Transporter chief , beam the landing party to the bridge"
-=- Blue Wave/DOS v2.30 [NR]
--- SLMAIL v4.5a  (#0384)
---------------