MC> Anyhoo Charles, I am VERY open for advise? Have any clues?
MC> Thanks again for the reply, and will be waiting for your help.
Mark:
        You say that the version of QmPro you have is pretty old.
Depending on how old it is, I have an idea which MAY solve your problem.
When you go into the Modem Configuration Function, did you SAVE the
changes BEFORE you Exited the Configuration Process. With the older
versions of QmPro this was a very Necessary Step or else all you Changes
would NOT be recorded. The Save function was on the Right Hand of the
screen Just above or below the Exit function, if I remember correctly...
You may want to check that out... If you have E-mail capability,
messages to me would arrive much quicker than in this conference. Use
any of my addresses below.
Charles Raine           Internet: rainec@cyberspc.mb.ca
Phone: (204) 895-0940             charles.raine@mwcs.mb.ca
                                  charles_raine@mbnet.mb.ca
                       Home Page: http://www.cyberspc.mb.ca/~rainec
--- QScan/PCB v1.17b / 01-0105
---------------