Kris,

I have solved the problem by using the version of the Laserjet driver
for the Brother 2060 which came with eCS RC4.

Just to explain a little further, the printer is attached to the eCS
box via USB and is then set as a shared printer on my peer to peer
network.  On the Windows box I then created a network printer using
the Brother but, whenever I have done this, Windows comes up with a
message saying the correct driver is not installed - so I installed
the Brother Windows driver on that box.  This worked fine with all the
documents sent from the Windows box and now works fine with the
different driver on the eCS box. 

I've always done it this way in the past with earlier printers and
never had a problem.  My experience with Windows is pretty limited and
I only use it as I have 2 accounting programs for my work that will
only run on Windows - so I do as little as possible with it!

Thanks for your time and advice.

kind regards,

Dave

--- In os2hardware{at}yahoogroups.com, Kris Steenhaut
 wrote:
>
> dwl100tr ha scritto:
> >
> > Thanks for the reply. The printer is already attached to the eCS box
> > directly through USB and shared
> >
> Shared, with wath?
> >
> > - that's how my Windows box uses it -
> >
> 
> > so I don't think the problem is to do with Windows in this case
> > (especially since I have the correct driver installed on the windows
> > box
> >
> What's the correct driver on Windows? What EMULATION has been selected 
> there?
> 
> Incidentally, if the "correct driver" interacts with the
printer, that 
> may cause the eCS driver to fail. Therefore I's suggested to detach the 
> printer completely form Windy. Otherwise you'll never know.
> >
> > and I can set portrait or landscape properly from there).
> >  
> >
> 
> > me to set the page orientation
> > radio buttons! I have noticed that, if I install a Postscript driver,
> >
> This is senseless, as your printer is not a postscript printer.
> >
> > I can set the radio buttons but this doesn't work since the 2070 isn't
> > Postscript! I don't understand what's going on!
> >
> Detach the printer from Windy and begin from scratch again. And
prior to any test, I strongly advise to uninstall everything printer
like  and have a reboot afterwards.
> 
> 
> -- 
> Groeten uit Gent,
> 
>    Kris
>




 
Yahoo! Groups Links

 To visit your group on the web, go to:
    http://groups.yahoo.com/group/os2hardware/

 Your email settings:
    Individual Email | Traditional

 To change settings online go to:
    http://groups.yahoo.com/group/os2hardware/join
    (Yahoo! ID required)

 To change settings via email:
    mailto:os2hardware-digest{at}yahoogroups.com 
    mailto:os2hardware-fullfeatured{at}yahoogroups.com

 To unsubscribe from this group, send an email to:
    os2hardware-unsubscribe{at}yahoogroups.com

 Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 

---