Kees Bergwerf wrote in a message to Shawn Highfield:

 SH> It sits at a "Did not detect ANSI" continue Y/N screen.  Nothing is
 SH> displayed remotly.

 KB> That's bad :-(, the door should end by itself.


It will.


 SH>  13 Nov 10:22:42 WAVE BEGIN
 SH>  13 Nov 10:22:42 WAVE Connection Speed.....: 0 Baud
 SH>  13 Nov 10:22:42 WAVE Free Memory..........: 262144

 KB> ..that is incredible, this is my wave.log (local):
 KB>  11 Nov 21:15:32 WAVE BEGIN
 KB>  11 Nov 21:15:32 WAVE Connection Speed.....: 0 Baud
 KB>  11 Nov 21:15:32 WAVE Free Memory..........: 262144
 KB> [..]

 KB> Did you see, the same amount of free memory 8-)
 KB> I have a lot more free memory..

The memory is determined by the compiler in this case FPC. When WAVE was
compiled , the compiler was told to reserve 500 K of heap. Thats why it
shows 250 K available. Actually the program will use as much heap as it
needs. Remember were dealing with flat model memory...limited only by what
you have installed.
But this is getting a little off topic.


frank_mccormick{at}radio-canada.ca 
---